![]() If the fuse does not blow it’s most likely a faulty trim motor. If the fuse blows again there is a most likely a fault in the trim module or other related wiring. ![]() If the fuse blows again, remove the two wires running to the trim motor inside the trim module and cycle the trim up and down again. If the 7.5 amp fuse is blown, replace it and cycle the trim up and down. ![]() The 7.5 amp fuse supplies power to the trim motor via the trim module. Guitar Hero Nokia Java Games - Download with Nokia, Samsung, Motorola, LG, Sony Ericsson, Blackberry and for all other Java supported J2ME mobile phones. If you hear an audible “click” when the up or down trim button is depressed, it is normally caused by a blown 7.5A trim fuse. Verify there is a good 7.5A trim fuse installed in the MPEM or Coil Box. Inspect the seal and replace if necessary. Water intrusion into the motor housing is typically caused by a faulty trim cover seal. ![]() When the boot fails, it allows water to enter the trim module and contaminate or short the internal circuits First, remove the trim module cover and inspect the motor housing for signs of water intrusion. A common failure with the design of the trim module is circuit board failure due to water intrusion caused by an improperly installed or faulty boot. The following process will test the trim module on 1995 and newer SeaDoos without iControl to determine if it is operating within specification. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |